DeltaFlightcase

Projects
Participants	Ultratux
Skills	Woodworking, measurements, painting
Status	Active
Niche	Mechanics
Purpose	Use in other project

Building a proper flightcase for a Cerberus-derived delta 3D printer. It ought to be flexible enough to house both the newer -printed- model and the original model in ways that even rough treatment will likely be survived gloriously.

Challenges:

• Find ways to keep weight limited so it can still be carried by a single person.
• Determine how to best design inside of case to accommodate the different variations of the cerberus.
• Find some way to cut foam into arbitrary shapes
• Find affordable sources for support foam and 'hang en sluitwerk' plus wheels.

Due date: no later than December 19th, 2014

Challenges met:

• Cheap non-birch 9 mm plywood; good compromise between price, sturdyness and weight.
• Found wheels and butterfly-lock-thingys in my attic.
• Ordered pre-cut 'hard foam' at some shop, so possibly avoided cutting it myself.
• Protection will basically be just a tight fit inside between 20mm hard foam plates