PCB Techinc Logo

From Technologia Incognita
Revision as of 20:25, 30 August 2013 by Brainsmoke (talk | contribs) (Techinc Logo PCB mkII (on its way))
Jump to: navigation, search
Projects
Techinc logo pcb.jpg
Participants Brainsmoke
Skills Etching, Soldering
Status Finished
Niche Electronics
Purpose World domination

Since our logo is a working PCB design, we thought it was time we have a working circuit.

Techinc Logo PCB mkII

techinc_badge ordered from iTead studio

Test batch.jpg

Kicad logo.png

Build Instructions

Pre-tin all the pads you will be using.

When soldering the LEDs to the board you must start with the upper most one.

the cathode (negative) must be on the outer most pad

starting clockwise, we will add all the other LEDs.

you must rotate the NEXT LED so the polarity is reversed. do this for every LED you have until you have soldered all the LEDs.

you can figure out the polarity of your SMD LED here http://www.niktronixonline.com/Articles.asp?ID=140

add the 27 ohm resistors in the positions shown below

add the final resistor

finally, solder on the chip and the power leads

and it should light up!
Working logo badge.jpg

Schematic

Techinc-logo-schematic.png

Circuit board

Techinc pcb.png svg

Code for AVR

File:Techinc badge code.tar.gz

https://github.com/techinc/techinc_logo_avr

More Pictures

Techinc pcb sheet.jpg

Techinc logo pcb.jpg