Difference between revisions of "PCB Techinc Logo"
Brainsmoke (talk | contribs) m (→Techinc Logo PCB mkII (on its way)) |
Brainsmoke (talk | contribs) m (→Techinc Logo PCB mkII (on its way)) |
||
| Line 8: | Line 8: | ||
Since our logo is a working PCB design, we thought it was time we have a working circuit. | Since our logo is a working PCB design, we thought it was time we have a working circuit. | ||
| − | =Techinc Logo PCB mkII | + | =Techinc Logo PCB mkII= |
[https://github.com/techinc/techinc_badge techinc_badge] ordered from [http://imall.iteadstudio.com/open-pcb/pcb-prototyping.html iTead studio] | [https://github.com/techinc/techinc_badge techinc_badge] ordered from [http://imall.iteadstudio.com/open-pcb/pcb-prototyping.html iTead studio] | ||
Revision as of 20:25, 30 August 2013
| Projects | |
|---|---|
| |
| Participants | Brainsmoke |
| Skills | Etching, Soldering |
| Status | Finished |
| Niche | Electronics |
| Purpose | World domination |
Since our logo is a working PCB design, we thought it was time we have a working circuit.
Contents
Techinc Logo PCB mkII
techinc_badge ordered from iTead studio
Build Instructions
Pre-tin all the pads you will be using.
When soldering the LEDs to the board you must start with the upper most one.
the cathode (negative) must be on the outer most pad
starting clockwise, we will add all the other LEDs.
you must rotate the NEXT LED so the polarity is reversed. do this for every LED you have until you have soldered all the LEDs.
you can figure out the polarity of your SMD LED here http://www.niktronixonline.com/Articles.asp?ID=140
add the 27 ohm resistors in the positions shown below
add the final resistor
finally, solder on the chip and the power leads
and it should light up!
Schematic
Circuit board
Code for AVR
File:Techinc badge code.tar.gz
https://github.com/techinc/techinc_logo_avr
More Pictures
