Difference between revisions of "PCB Techinc Logo"
Brainsmoke (talk | contribs) (→Build Instructions) |
Brainsmoke (talk | contribs) |
||
| Line 57: | Line 57: | ||
add the final resistor | add the final resistor | ||
| − | + | solder on the chip with the notch pointing to the right | |
| + | |||
| + | Finally solder the battery clip on the backside | ||
and it should light up!<br> | and it should light up!<br> | ||
Revision as of 13:20, 1 August 2014
| Projects | |
|---|---|
| |
| Participants | Brainsmoke |
| Skills | Etching, Soldering |
| Status | Finished |
| Niche | Electronics |
| Purpose | World domination |
Since our logo is a working PCB design, we thought it was time we have a working circuit.
Contents
Techinc Logo PCB mkII
techinc_badge ordered from iTead studio
Build Instructions
| Element | Quantity |
| Attiny85 | 1 |
| Red LED SMD 1206 | 4 |
| Yellow LED SMD 1206 | 4 |
| Resistor 10K Ohm SMD 1206 | 1 |
| Resistor 18 Ohm or 22 Ohm SMD 1206 | 4 |
| CR2032 Battery | 1 |
| CR2032 Battery Clip | 1 |
| 2x3 .1" Pin Header for ISP (optional) | 1 |
| Safety pin (optional) | 1 |
Pre-tin all the pads you will be using.
When soldering the LEDs to the board you must start with the upper most one.
the cathode (negative) must be on the outer most pad
starting clockwise, we will add all the other LEDs.
you must rotate the NEXT LED so the polarity is reversed. do this for every LED you have until you have soldered all the LEDs.
you can figure out the polarity of your SMD LED here http://www.niktronixonline.com/Articles.asp?ID=140
add the 18 or 22 ohm resistors in the positions shown below
add the final resistor
solder on the chip with the notch pointing to the right
Finally solder the battery clip on the backside
and it should light up!
Schematic
Circuit board
Code for AVR
File:Techinc badge code.tar.gz
https://github.com/techinc/techinc_logo_avr
More Pictures
