Difference between revisions of "DeltaFlightcase"
m |
|||
| Line 8: | Line 8: | ||
Challenges: | Challenges: | ||
| − | * Find ways to keep weight limited so it can still be carried by a single person. | + | * <s>Find ways to keep weight limited so it can still be carried by a single person.</s> |
* Determine how to best design inside of case to accommodate the different variations of the cerberus. | * Determine how to best design inside of case to accommodate the different variations of the cerberus. | ||
* Find some way to cut foam into arbitrary shapes | * Find some way to cut foam into arbitrary shapes | ||
| − | * Find affordable sources for support foam and 'hang en sluitwerk' plus wheels. | + | * <s>Find affordable sources for support foam and 'hang en sluitwerk' plus wheels.</s> |
Due date: no later than December 19th, 2014 | Due date: no later than December 19th, 2014 | ||
| Line 18: | Line 18: | ||
* Cheap non-birch 9 mm plywood; good compromise between price, sturdyness and weight. | * Cheap non-birch 9 mm plywood; good compromise between price, sturdyness and weight. | ||
| − | * Found wheels and butterfly-lock- | + | * Found wheels and butterfly-lock-thingies in my attic. |
* Ordered pre-cut 'hard foam' at some shop, so possibly avoided cutting it myself. | * Ordered pre-cut 'hard foam' at some shop, so possibly avoided cutting it myself. | ||
* Protection will basically be just a tight fit inside between 20mm hard foam plates | * Protection will basically be just a tight fit inside between 20mm hard foam plates | ||
Revision as of 02:54, 10 December 2014
| Projects | |
|---|---|
| Participants | Ultratux |
| Skills | Woodworking, measurements, painting |
| Status | Active |
| Niche | Mechanics |
| Purpose | Use in other project |
Building a proper flightcase for a Cerberus-derived delta 3D printer. It ought to be flexible enough to house both the newer -printed- model and the original model in ways that even rough treatment will likely be survived gloriously.
Challenges:
-
Find ways to keep weight limited so it can still be carried by a single person. - Determine how to best design inside of case to accommodate the different variations of the cerberus.
- Find some way to cut foam into arbitrary shapes
-
Find affordable sources for support foam and 'hang en sluitwerk' plus wheels.
Due date: no later than December 19th, 2014
Challenges met:
- Cheap non-birch 9 mm plywood; good compromise between price, sturdyness and weight.
- Found wheels and butterfly-lock-thingies in my attic.
- Ordered pre-cut 'hard foam' at some shop, so possibly avoided cutting it myself.
- Protection will basically be just a tight fit inside between 20mm hard foam plates
