Difference between revisions of "DeltaFlightcase"
(Flightcase for a Cerberus-derived delta 3D printer) |
|||
| Line 1: | Line 1: | ||
{{Project | {{Project | ||
|ProjectSkills=Woodworking, measurements, painting | |ProjectSkills=Woodworking, measurements, painting | ||
| − | |ProjectStatus= | + | |ProjectStatus=Active |
|ProjectNiche=Mechanics | |ProjectNiche=Mechanics | ||
|ProjectPurpose=Use in other project | |ProjectPurpose=Use in other project | ||
| Line 14: | Line 14: | ||
Due date: no later than December 19th, 2014 | Due date: no later than December 19th, 2014 | ||
| + | |||
| + | Challenges met: | ||
| + | |||
| + | * Cheap non-birch 9 mm plywood; good compromise between price, sturdyness and weight. | ||
| + | * Found wheels and butterfly-lock-thingys in my attic. | ||
| + | * Ordered pre-cut 'hard foam' at some shop, so possibly avoided cutting it myself. | ||
| + | * Protection will basically be just a tight fit inside between 20mm hard foam plates | ||
Revision as of 22:50, 9 December 2014
| Projects | |
|---|---|
| Participants | Ultratux |
| Skills | Woodworking, measurements, painting |
| Status | Active |
| Niche | Mechanics |
| Purpose | Use in other project |
Building a proper flightcase for a Cerberus-derived delta 3D printer. It ought to be flexible enough to house both the newer -printed- model and the original model in ways that even rough treatment will likely be survived gloriously.
Challenges:
- Find ways to keep weight limited so it can still be carried by a single person.
- Determine how to best design inside of case to accommodate the different variations of the cerberus.
- Find some way to cut foam into arbitrary shapes
- Find affordable sources for support foam and 'hang en sluitwerk' plus wheels.
Due date: no later than December 19th, 2014
Challenges met:
- Cheap non-birch 9 mm plywood; good compromise between price, sturdyness and weight.
- Found wheels and butterfly-lock-thingys in my attic.
- Ordered pre-cut 'hard foam' at some shop, so possibly avoided cutting it myself.
- Protection will basically be just a tight fit inside between 20mm hard foam plates
