Difference between revisions of "Cut/audio setup glitches"
(Please don't use an article page as a discussion page, TYVM) |
(→beep gone?) |
||
| Line 10: | Line 10: | ||
** make a proper mount in the ceiling | ** make a proper mount in the ceiling | ||
* The amp should be moved near the mixing board | * The amp should be moved near the mixing board | ||
| − | ** This should alleviate the problems with electrical interference on the line to the amp, and ultimately rid us of the annoying ~10KHz beep | + | ** This should alleviate the problems with electrical interference on the line to the amp, and ultimately rid us of <s>the annoying ~10KHz beep</s> ''what beep?'' |
** Alternatively, replace the current cables with shielded cable | ** Alternatively, replace the current cables with shielded cable | ||
Revision as of 17:39, 15 January 2014
| Papercut | |
|---|---|
| SubGroup | AV |
| Status | Pending |
| Type | Infrastructure |
| Contact | User:Justa |
- The speakers should be hanged properly
- These speakers are much heavier than the old ones
- please don't hang them from conduits or pipes!
- make a proper mount in the ceiling
- The amp should be moved near the mixing board
- This should alleviate the problems with electrical interference on the line to the amp, and ultimately rid us of
the annoying ~10KHz beepwhat beep? - Alternatively, replace the current cables with shielded cable
- This should alleviate the problems with electrical interference on the line to the amp, and ultimately rid us of
