Difference between revisions of "Circular plate sawtable"
(Created page with "{{Inventory |Description=Circular table saw for thin plate materials |Make=Mechanik Muntelier AG |Model=VA1 |Manufacturer Link=http://www.mechanik-muntelier.com/cms03/showlinx...") |
m |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
{{Inventory | {{Inventory | ||
| + | |Picture=38683-10-3450.jpg | ||
|Description=Circular table saw for thin plate materials | |Description=Circular table saw for thin plate materials | ||
|Make=Mechanik Muntelier AG | |Make=Mechanik Muntelier AG | ||
| Line 11: | Line 12: | ||
|Owner=Remko | |Owner=Remko | ||
}} | }} | ||
| − | Circular saw to cut plate materials of max 6 mm thickness. Refer to manufacturer site link above for details. Usable for PCBs, many kinds of plastics, '''non-ferrous metals IF USED PROPERLY to max 4mm thickness | + | Circular precision saw to cut plate materials of max 6 mm thickness. Refer to manufacturer site link above for details. Usable for PCBs, many kinds of plastics to max 6mm thickness, '''non-ferrous metals IF USED PROPERLY''' to max 4mm thickness. |
| + | This tool is made for very precise cuts, so it needs to be handled with respect and patience, without forcing it. | ||
| − | The power switch was bad, | + | The power switch was bad, I took it [the switch] apart and repaired it [[User:Ultratux|Ultratux]] 02:12, 14 November 2013 (CET) |
Latest revision as of 02:21, 14 November 2013
| TechInc Inventory | |
|---|---|
| |
| Description | Circular table saw for thin plate materials |
| Make | Mechanik Muntelier AG |
| Model | VA1 |
| Manufacturer Link | http://www.mechanik-muntelier.com/cms03/showlinx.asp?id=1&lang=e |
| Category | Mechanics |
| Operational Status | Working |
| Super Users | ultratux, Remko |
| Received at | 2013/11/09 |
| Acquisition Details | On loan from Remko (Urban resort) |
| Owner | Remko |
Circular precision saw to cut plate materials of max 6 mm thickness. Refer to manufacturer site link above for details. Usable for PCBs, many kinds of plastics to max 6mm thickness, non-ferrous metals IF USED PROPERLY to max 4mm thickness. This tool is made for very precise cuts, so it needs to be handled with respect and patience, without forcing it.
The power switch was bad, I took it [the switch] apart and repaired it Ultratux 02:12, 14 November 2013 (CET)
