Difference between revisions of "Stapled felt cover for E-Book reader"
| Line 1: | Line 1: | ||
{{Project | {{Project | ||
| − | |picture=Cover_for_ebook_reader_- | + | |picture=Cover_for_ebook_reader_-_14.jpg |
|ProjectSkills=stapling | |ProjectSkills=stapling | ||
|ProjectStatus=Finished | |ProjectStatus=Finished | ||
Revision as of 23:24, 20 December 2013
| Projects | |
|---|---|
| |
| Participants | Becha |
| Skills | stapling |
| Status | Finished |
| Niche | Sewing |
| Purpose | Fun |
Quick hack: I made a cover for E-book reader using stapler :)
Step by step instructions:
What you need is: felt, velcro, stapler, scissors.
- Cut felt to measure: size of E-Book reader + 1cm extra on every side.
- Staple the outer corners first, planning to have them as "triangles". I started with 2 staples on each side...
- ... but that was too little so I added 3rd staple. // Cut the "triangles" off.
- Now, add one of the inner corners. Staple on the narrow side of "reader".
- Then fold the cover, and staple from the OUTSIDE of the wide side of the "reader".
- Try if the reader fits in, and adjust by stapling extra here-and-there.
- For the "closing" mechanism: cut the ribbons, and staple them to the end of "flap".
- Cut velcro in pieces that fit the width of ribbons.
- Staple velcro to the "bottom" of the cover.
- Next, staple velcro to the ribbon. Cut the excess of ribbon.
- Add some extra staples, to make velcro more attached to the ribbon.
- This is how it looks finished, from the outside!
- This is the final look, when open.
