You do not have permission to edit this page, for the following reason:
The action you have requested is limited to users in the group: emailconfirmed.
''We are looking at purchasing bearings and fittings for an extra air exhaust fan''
4 new bearings, couple of pipe joints and pipe adapters
Estimated at somewhere around 70 euros
* €0 -- [[User:|Mr. Banker]]
* €10 -- [[User:Chotee|Chotee]] paid by Revbank
* €5 -- [[User:Bigmac|bigmac]]
* €10 -- [[User:Julf|Julf]]
* €5 -- [[User:CodeAsm|CodeAsm]] (paid cash, 24 june)
* €10 -- sn0wcrash
* €10 -- [[User:Brainsmoke|Brainsmoke]] (already paid!)
* €10 -- [[User:Wally|Wally]] (already paid!)
* €10 -- [[User:ultratux|ultratux]] (already paid)
[contents of email sent that initiated it]
With our expanding space and equipment we revised and installed a
donated air fan in the server room a while ago. We have one other such
fans which needs new bearings, and we have our primary source of air
refreshment, our "Space fan" tucked high above the ceiling.
Now our space fan has suffered from broken/bad bearing from the start.
We since have found out how to replace them (by complete disassembly).
I suggest to buy new bearings for the 3rd fan we have, install those,
replace the space fan by this 3rd fan, and also buy and install new
bearings in that fan. That fan subsequently goes to get installed as
supplemental exhaust fan for the laser cutter and the 3D printers.
Often the laser cutter needs all the suction there is, to keep the smoke
from interfering with the laserbeam. This leads to all other inlets
getting blocked off. This gets more and more tiresome, especially since
often suction is needed at multiple spots simultaneously, like when
painting, gluing, sawing, sanding, or printing with ABS. And the fans
were already donated to us.
To make both fans optimally operational again, 4 bearings are needed.
Exact price escapes me now, Piele knows. But I reckon something around
4x 8 euros = 32 euros. To install the 3rd fan on the laser cutter we'd
need some 150/160mm T-joints, perhaps a few adapters 150->130mm and not
much else. Perhaps 25 or 35 euros for that.
I'm willing to do most of the 'heavy lifting'; replace the bearings,
(dis)mount and (re)install the fan(s), etc.
Would I get some funding support from some of you ? I can make a pledge.
Laser cutter guys: this concerns you too; to get better, nicer more
precise cuts, more powerful suction is essential.
This is a minor edit
Watch this page