PCB Techinc Logo

From Technologia Incognita
Revision as of 01:15, 18 June 2012 by Brainsmoke (talk | contribs) (Code for AVR)
Jump to: navigation, search
Projects
Participants Brainsmoke
Skills Etching, Soldering
Status Active
Niche Electronics
Purpose World domination

Since our logo is a working PCB design, we thought it was time we have a working circuit.

Build Instructions

Pre-tin all the pads you will be using.

When soldering the LEDs to the board you must start with the upper most one.

the cathode (negative) must be on the outer most pad

starting clockwise, we will add all the other LEDs.

you must rotate the NEXT LED so the polarity is reversed. do this for every LED you have until you have soldered all the LEDs.

you can figure out the polarity of your SMD LED here http://www.niktronixonline.com/Articles.asp?ID=140

add the 27 ohm resistors in the positions shown below

add the final resistor

finally, solder on the chip and the power leads

and it should light up!
Working logo badge.jpg

Schematic

Techinc-logo-schematic.png

Circuit board

Techinc pcb.png svg

Code for AVR

File:Techinc badge code.tar.gz

https://github.com/brainsmoke/techinc_logo_avr (needs to be moved to techinc group)

More Pictures

Techinc pcb sheet.jpg

Techinc logo pcb.jpg