ACTA/Ventilation

From Technologia Incognita
Revision as of 23:47, 15 March 2013 by Ultratux (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
Projects
Air-infra.jpg
Participants Ultratux
Skills
Status Finished
Niche Mechanics
Purpose Infrastructure

Introduction

With a heavy industrial fan kindly donated by Urban Resort/ACTA, a generous amount of my time+effort and a heap of community money and patience, we have now installed and operational(*) a hefty, powerful, versatile ventilation- or air suction system.

Layout

It encompasses six inlets in our space: {two in soldering area, one over general workbench, three in dirty room} and two future projected ones: one or more in clean room and one over kitchen area. The general idea is to block/close inlets when not in use, thereby not losing suction power. The smaller kitchen inlet will be open all the time, however.

Powered by

At the heart of the system is a large industrial fan powered by a ~300watt motor, which for reasons of noise suppression we built inside a padded wooden box which is suspended isolated with rubber rings to the ceiling in the dirty room. Still, the fan is audible/noisy, especially when cold (first 10-30 minutes). Lack of lubrication mostly. We're still looking into that; we know we need a special grease, Shell Alvania grease, lithium-based. We cannot, however, see where to insert that, unless we're prepared to take the motor/fan assembly completely apart.

Future enhancements projected

As a future project enhancement, we'd like to automate and protect the system further by it having a temperature readout, cut-off overheat protection, and a timer switch. For this purpose a temperature probe+module has been purchased already, and the probe installed on the fan engine. The rest however, needs to be designed and built. We already have a solid state relay for it.

Pictures or it didn't happen

Some pictures I took of the building stages and the finished inlets and how they ought to be blocked by the red plastic plugs.

Fanincasing.jpg
The large fan as it is meant to get mounted in its case. The entire thing hanging from ceiling by rubber-insulated bolts

Fanonceiling.jpg
The fan installed in its final position above the ceiling, with 160mm outlet hose connected.

Dirtyroom-inlets.jpg
The three inlets in the dirty room, two of them closed by red plugs, third one connected by flexible hose. Suction has proven strong enough to suck up sawdust, grit, etc.

Inlets-detail.jpg
The hose tube fits snugly in the ceiling plug; so there is no holding mechanism to defeat gravity; it holds there without help. Gently pulling the plug while turning/wiggling will release it.

Inlet-closeup.jpg
Detail view of the business end of a flex hose. Note that the same red plug, reversed, fits the hose. How to hold/place/connect to or above project, engine or tool is left as an exercise for the reader.

Airdistributionbox.jpg
What hackerish uglyness^Wepicness actually hides above those ceiling tiles in some spots.

Poweron.jpg
Pending a neater system, this big yellow switch is what turns it on and off now.



(*) It is fully operational. However, what it lacks at this point is the timer + overheat electronics, the kitchen inlet, the clean room inlet. These in no way inhibit its use.