AnusCopter
| Projects | |
|---|---|
| |
| Participants | Ranzbak, The JinX |
| Skills | Soldering, Electronics, Coding, UI design |
| Status | Getting parts |
| Niche | Electronics |
| Purpose | Fun |
Build log
- 2013-11-20 put AeroQuad in case
- 2013-11-23 assembled body, screwed motors on with 16x M3 (~6mm)
- 2013-11-26 charged batteries, added receiver and battery strap
- 2013-11-27 battery monitor leads (and header for LEDs) added
- 2013-12-04 XT60 to power board soldered
- 2013-12-07 8x 3.5mm gold bullet connectors, installed ESCs, 6 pin micro JST to GPS
In transit
4x Turnigy Multistar 30 Amp Multi-rotor Brushless ESC
FS-TH9X-B-Module
Some 8045 CW CCW Propellers
10x Male+Female XT60 connector
25x M3 7mm Philips head screw
XBee Explorer Dongle + Quad-band Cellular Antenna SMA + SMA connector for XRF
T B A
Landing gear
Ultrasonic Range Finder (LV EZ-0)
Camera's and FPV transmitter / receiver
Components
HJ 450 "classic" frame
4x Turnigy D2822/17 1100KV Brushless
4x Turnigy Multistar 30 Amp Multi-rotor Brushless ESC
4x 8045 CW CCW Propellers
AeroQuad 32 Flight Control board v2
Turnigy 9X 2.4GHz 8Ch Receiver (V2)
2x Turnigy 2200mAh 3S (30C+35C) LIPO
2x XRF wireless RF radio UART RS232
LS20031 GPS
10 strand dupont cable female-female
Velcro tape <3
XT60 and 3.5mm gold bullet connectors
Accessoires
Turnigy 9XR Transmitter Mode 2 + 11.1v (3s) 2200mAh 1.5C LIPO
Turnigy Accucel-6 50W 6A Balancer/Charger
ToDo
Installing ESCs
Power wiring
Serial uplink (telemetry)
