FLSUN V400

From Technologia Incognita
Revision as of 01:40, 14 June 2024 by Grey (talk | contribs)
Jump to: navigation, search

FLSUN V400 Printer

Using the printer:

The v400 is a delta printer, its kinda fun to use. Its pretty hardy and fairly durable compared to an average 3d printer, and also fairly fast. Baring this in mind, if we stick to a known recipe of plastic and printer settings, it should Just Work:tm: most of the time.

It likes to run ESUN brand PLA+ (PLA-ST which is PLA with added herbs and spices that make it stronger) which is often < €15/kg. I've had great success with ESUN PLA+ and never had a clog with it.

Cura

To use it with Cura, you must do the following:

Install Cura

[Download](https://ultimaker.com/software/ultimaker-cura/#downloads) the latest Cura

Install Plugins

Open the Marketplace Open the marketplace.png

Install the z offset plugin

Zoffsetplugin.png

Install the moonraker plugin

Moonrakerplugin.png

Restart Cura

Restart cura.png

Add a new Printer

V400 - add a new printer.png

Then select "Non UltiMaker Printer". Expand the section labeled "Add a non-networked printer" even though this very much is a networked printer. Then scroll until you find Flsun, and select Flsun v400.

Select v400.png


  • Configure the printer by setting the START GCODE and END GCODE as below
  • Import v400 print settings
  • Connect to the printer (http://10.209.10.174)
Retrieved from "https://wiki.techinc.nl/index.php?title=FLSUN_V400&oldid=29047"