Difference between revisions of "ISpindel"
| Line 11: | Line 11: | ||
We created footprint for the various parts on the PCB. These can be found in the /libs dir in the repo. Furthermore we replaced the reset switch with a reed | We created footprint for the various parts on the PCB. These can be found in the /libs dir in the repo. Furthermore we replaced the reset switch with a reed | ||
switch so you can use a magnet to reset the iSpindel without opening the container. | switch so you can use a magnet to reset the iSpindel without opening the container. | ||
| + | |||
| + | == Why Bat43??? == | ||
| + | |||
| + | It seems to me that the selection of the diode to be a schottky is a critical one here! | ||
| + | According to the datasheet, the min. Input Low Voltage must be < 0.25×VIO while the Output Low Voltage is up to 0.1×VIO. | ||
| + | Therefore, this leaves 500mV where the BAT43 will drop around 300mV or more. So a regular silicium diode will fail in this setup! | ||
| + | Using a BAT43 or better is a requirement so to speak. | ||
Previous work: | Previous work: | ||
Revision as of 21:20, 8 June 2022
| Projects | |
|---|---|
.jpg)
| |
| Participants | Einnor, Justa, Sikkepitje |
| Skills | soldering, brewing, PCB Design |
| Status | Active |
| Niche | FoodHacks |
| Purpose | Fun |
iSpindel
iSpindel DIY continuous hydrometer, for measuring the realitive gravity / density of wort. Meant as an educational project for KWBG. We created footprint for the various parts on the PCB. These can be found in the /libs dir in the repo. Furthermore we replaced the reset switch with a reed switch so you can use a magnet to reset the iSpindel without opening the container.
Why Bat43???
It seems to me that the selection of the diode to be a schottky is a critical one here! According to the datasheet, the min. Input Low Voltage must be < 0.25×VIO while the Output Low Voltage is up to 0.1×VIO. Therefore, this leaves 500mV where the BAT43 will drop around 300mV or more. So a regular silicium diode will fail in this setup! Using a BAT43 or better is a requirement so to speak.
Previous work:
Look also here: [github.com/techinc/ispindel_kicad]
TODO-List:
-
Cleaned PCB repo (first version: Einnor) - Pannelization test (Einnor)
-
Reed-switch test/rework (Einnor) -
Footprint Battery Holder with sliding pads (Einnor) -
Footprint D1-Mini 8-pin version (justa)Done by Einnor -
Petling bottles order (justa)Done, 20220608. 10 pieces - Online-service (ubidots?) uitzoeken/selecteren (sikkepitje)
- Order more parts (Einnor + Justa)
- Test whole setup on a breadboard
-
setup a mailing list! 😁 (Justa)Done: beernerds@lists.techinc.nl
