Difference between revisions of "CNC-Mill"
(Created page with "{{Inventory |Description=CNC-mill with cast-iron Z-axis support and X/Y cross-table |Make=Commercial/DIY |Model=Commercial/DIY hybrid |Category=Mechanics |Operational Status=B...") |
|||
| Line 1: | Line 1: | ||
{{Inventory | {{Inventory | ||
| + | |Picture=CNC-mill2.jpg | ||
|Description=CNC-mill with cast-iron Z-axis support and X/Y cross-table | |Description=CNC-mill with cast-iron Z-axis support and X/Y cross-table | ||
|Make=Commercial/DIY | |Make=Commercial/DIY | ||
Revision as of 15:09, 15 November 2018
| TechInc Inventory | |
|---|---|
| |
| Description | CNC-mill with cast-iron Z-axis support and X/Y cross-table |
| Make | Commercial/DIY |
| Model | Commercial/DIY hybrid |
| Category | Mechanics |
| Operational Status | BROKEN |
| Super Users | justa |
| Received at | 2018/11/14 |
| Acquisition Details | Picked up as a donation to the space |
| Owner | Techinc |
This is a large, heavily built CNC-mill. It is not yet operational as the controllers need to be re-worked or replaced; but the mechanics are expected to generally work without further modification.
Special note should be taken that:
- The end-stop of the Z-axis is a small hall-sensor that needs to be affixed again in it's proper location OR replaced with an end-stop switch instead. - The Spindle motor seems to be having a fault; could be brushes, could be something else. NOTE: 36Volt AC !!!! Comes from controller-box!!! - The controller-box needs inspection and deserves some re-work. Note that the G-code interpreter is...not quite-up-to-par regarding modern standards/expectations
