Difference between revisions of "Diyspotwelder"
| Line 22: | Line 22: | ||
References: | References: | ||
| − | https://www.youtube.com/watch?v=vrlvqib94xQ - Handheld spotwelder design | + | * https://www.youtube.com/watch?v=vrlvqib94xQ - Handheld spotwelder design |
| − | http://www.instructables.com/id/How-to-Make-a-Spot-Welder-for-Cheap/ - Instrucable page belonging to video above. | + | * http://www.instructables.com/id/How-to-Make-a-Spot-Welder-for-Cheap/ - Instrucable page belonging to video above. |
| + | * https://www.youtube.com/watch?v=hTaGa93lOGU - How to modify the transformer | ||
| + | * http://hackaday.com/2014/07/21/spot-welder-dont-buy-it-build-it/ - the/a hackaday article. | ||
| − | + | Design references: | |
| − | http:// | + | * http://electronicdesign.com/power/novel-pc-compatible-ac-power-controller-uses-solid-state-relay - How to use an SSR to do high-power PWM control |
Revision as of 15:39, 14 August 2014
| Projects | |
|---|---|
| Participants | |
| Skills | Electronics, Metal- and woodworking, Soldering electronics programming |
| Status | Planning |
| Niche | Mechanics |
| Purpose | Infrastructure |
Lately, hackaday et al. have been supplying a number of reviews/buildlogs of DIY spotwelders. They all seem to be based around taking a used/surplus microwave transformer and removing the secondary (highvoltage) core , replacing it with a few turns of thick copper-cable which instead take the power from the primary coil and turns it into low-voltage, high-power.
Current state: We've liberated a transformer from a microwave; removed the secondary coil with a hacksaw. Saved the 'shunts'. It's now stored on a shelf below the 'woodworking-tables', next to the 'printer parts box'.
Meanwhile, Justa has found a nice two-conduit cable, used for supplying -48V power to telco-equipment. They contain 2 conductors, both consisting of 5-6 solid-core copper wires normally used to supply 20A+ each. Total cable-length is around 2meters, supplying up to 4 meters of heavy-duty copper-cable, useful for secondary coil. On one side, the copper cable has been finished with a galvanized-metal ring-lug; possibly to be replaced with a set of 'copper offset clamps' which seem perfect for the job.
The plan:
- Start with a simple test-setup to check if everything works like it should
- Add proper welding-terminals and enclosure
- Make an assembly with spring-loaded clamping system
- Add timing and/or power-control to it
- Add a foot-pedal system to it to allow two-hand operation
References:
- https://www.youtube.com/watch?v=vrlvqib94xQ - Handheld spotwelder design
- http://www.instructables.com/id/How-to-Make-a-Spot-Welder-for-Cheap/ - Instrucable page belonging to video above.
- https://www.youtube.com/watch?v=hTaGa93lOGU - How to modify the transformer
- http://hackaday.com/2014/07/21/spot-welder-dont-buy-it-build-it/ - the/a hackaday article.
Design references:
- http://electronicdesign.com/power/novel-pc-compatible-ac-power-controller-uses-solid-state-relay - How to use an SSR to do high-power PWM control
