Difference between revisions of "ActaRoom2 proposal/Notes20140212"

From Technologia Incognita
Jump to: navigation, search
m
(very short summary)
Line 1: Line 1:
 +
==Long story short==
 +
 +
* People will make a hole in the wall on Saturday, starting at 10:00
 +
* Space needs to be clear of dust, tools, sharp stuff before Sunday because of the Young hackspace event
 +
* Newspaper wall will be painted next week. Please do not put desks, shelves or other stuff against this wall before the painting
 +
 
==Young hackspace on Sunday==
 
==Young hackspace on Sunday==
 
Becha: both spaces are needed for the young hackspace. Please make sure that the space is usable. So, no tools, sharp edges, wet paint, etc on Sunday please
 
Becha: both spaces are needed for the young hackspace. Please make sure that the space is usable. So, no tools, sharp edges, wet paint, etc on Sunday please

Revision as of 01:18, 13 February 2014

Long story short

  • People will make a hole in the wall on Saturday, starting at 10:00
  • Space needs to be clear of dust, tools, sharp stuff before Sunday because of the Young hackspace event
  • Newspaper wall will be painted next week. Please do not put desks, shelves or other stuff against this wall before the painting

Young hackspace on Sunday

Becha: both spaces are needed for the young hackspace. Please make sure that the space is usable. So, no tools, sharp edges, wet paint, etc on Sunday please

Painting

Narya: ErwinC64 and Narya will do this next week

  • Glass fiber stuff on the newspaper wall (tip from Rop: use gloves)
  • Make it smooth
  • Paint it white
  • We will buy the materials and try to keep the costs low
  • Only do the newspaper wall (quiet room might get shelves, a doorway will be made in the big wall first)

Ceiling

Preferably no big changes. Perhaps install impregnated fabric, but there is no rush with that.

Doors

  • UR donated two doors
  • Minimal width: plotter should be able to fit through it
  • Maarten: no need for doors. Benefit will be that the rooms will not be too separate. Look one month from now if this works, otherwise install doors then. Preferable 180cm wide
  • Piele: make door opening two doors wide
  • Rop: in which direction? Justa: can be decided later
  • Justa: make hole, see if wall is sturdy enough to install frame. If not, make sure to strengthen the frame
    • Some suggestions mentioned: wood construction, wedge, jack
  • Cmpxchg: can we get frame via UR? Probably yes. Wood is available via Remko
  • Rop: are there plans to start tomorrow? People in room: no, but perhaps others would like to start?

Saturday 10:00 people will work on making hole in the wall

Who brings what will be arranged via e-mail

Floor in dirty room

  • Justa brought laminate
  • Maarten: floor will be ruined if people will decide later (after discussion with members) that the wall is taken down between the two small rooms
  • Decision: wait with floor, focus on new room first. Floor panels will be stored in storage room to prevent damage to the panels
  • Test if existing carpet is suitable as underlayment

Electricity

  • Philip: already plans for electricity?
  • Maarten: power block is in place including wiring. Needs to be hooked on to the fuse box
  • Location of the fuse box? Depends on destination of the smaller rooms, which needs to be discussed with members. Options mentioned:
    • in current clean room behind the fridge (water needs to be installed on other wall in that case)
    • Phicoh: perhaps between kitchen and emergency door
    • install in clean room and place it somewhere else later (problem: rewiring)


Remarks and suggestions

Skinnr

  • were there other suggestions after the proposal? Except a comment about the door width (Ultratux: make it wide enough for the plotter) there were no other suggestions or objections. The response was positive in general.
  • are there official drawings of the building? No, just floor plans without details. Suggestion: make sure to document what we do ourselves