LAOSLaserCutter

TechInc Inventory
Description	Laser Cutter on loan from Daan Uttien
Category	Mechanics
Operational Status	Working
Super Users	User:Amx109, User:Narya
Received at	2014/01/31
Acquisition Details	on temporary loan
Owner	Daan Uttien

This laser cutter has been given on temporary loan to TechInc by Daan.

It is to be used only bu those who have received training to use it.

Description

The laser cutter is <make/model> 60 Watt C02 laser cutter and engraver. The electronics have been replaced with the LAOS laser electronics (link).

The laser cutter is currently networked and requires the user to install and configure Visicut(link) for usage.

Machine Maintainers

Should anything with the machine go wrong, please turn it off and contact one of the following

amx109 Narya sjaan

Usage

You must have received training to use this machine.

Your laptop must have Visicut installed and be configured to talk to the printer, which is network enabled.

• Step 1 - switch on the machine
• Step 2 - check that the suction is switched on, and the water for the coolant is flowing
• Step 3 - place material on bed, secure it if necessary
• Step 4 - close lid, and 'execute' the print in visicut
• Step 5 - watch the print carefully - DO NOT leave the laser cutter unattended - fire is a big risk
• Step 6 - ...
• Step 7 - PROFIT

Settings for Cutting

Power should never be higher than 90%

Cost

The agreed cost has been set to 10 EUR per hour. This covers basic costs of things that need replacing, such as mirrors, laser tube, belts etc.

Maintenance

Regular maintenance to be undertaken should be

• cleaning of mirrors
• calibration of the Z height
• check for damage to mirrors
• checking belts for tension
• checking calibration via known print (eg 10mm x 10mm cube)